NAMM 2014: Jim Dunlop Introduces MXR FET Driver Pedal — with Demo Video
Featuring a unique circuit design, the MXR FET Driver captures the rich, creamy sound of an overdriven tube amplifier by cascading an op-amp gain stage into a FET stage.
This pedal thickens up lead tones with musical, amp-like distortion and sustain without the fragility and inconsistency associated with tubes.
The FET Driver features a simple but responsive set of controls. Set your volume level with the Output control, and then use the Drive control to dial in the grit, from subtle soft-clipping to early stage distortion. Fine tune the FET Driver’s sound by tweaking Hi and Lo boost/cut controls, and push the Hi Cut switch to roll off high end frequencies for a rounder sound or when playing in high volume situations where excess noise is apparent.
• Organic, amp-like overdrive and distortion
• Two-band EQ section for detailed shaping of distorted signal
• Hi Cut switch rolls off high end for rounder, warmer sound
• True bypass switching
SHIPPING FEBRUARY 2014
Check out Jim Dunlop's "New Gear for 2014" page HERE.
You Might Also Like...
1 hour 2 min ago
Pantera Combo Offer: Get New Pantera Issue of Revolver and Limited 'Far Beyond Driven' T-Shirt for $24.991 hour 4 min ago
16 hours 14 min ago
20 hours 34 min ago
1 day 1 hour ago
May 2014 Guitar World: Zakk Wylde & Joe Satriani, How to Build a Pedal Board, John Frusciante, Death Angel, Tabs, Lessons and More1 day 2 hours ago
1 day 15 hours ago